Thingiverse
MPX Funcub - Straight wing jointers
door apocalypsedude
22
Downloads
16
Likes
1
Makes
EDIT 08/2019: Added a verion without the middle section for rods/tubes going straight through. Files are named "straight through".
________________________________________________________________
These are straight wing jointers for the famous Multiplex Funcub.
I wanted my Funcub without any dihedral for a better look and feel.
The jointers are similar to the stock ones, but without and upward angle and will fit the stock wings and glass fiber rods. Installing is also the same as the stock version.
Mine are printed out of PLA which works fine. Use 4 perimeters, 4 top and bottom layers and 50% infill.
The orientation on the print bed should be as given by the files. A little support for the overhangs is needed.
________________________________________________________________
These are straight wing jointers for the famous Multiplex Funcub.
I wanted my Funcub without any dihedral for a better look and feel.
The jointers are similar to the stock ones, but without and upward angle and will fit the stock wings and glass fiber rods. Installing is also the same as the stock version.
Mine are printed out of PLA which works fine. Use 4 perimeters, 4 top and bottom layers and 50% infill.
The orientation on the print bed should be as given by the files. A little support for the overhangs is needed.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!