Thingiverse
MQ-1 Rocket
von AserN
6
Downloads
4
Likes
0
Makes
Rocket MK-1 or Mississippi Queen - 1, a small rocket for printing on a 3D printer. The rocket is 53 cm long and 14 cm wide and deep.
The project is designed for printing without the use of supports.
The engine for the rocket is also printed on a 3D printer. (The engine project will be a little later) Its fastening is carried out due to the printed M20 thread with a pitch of 2.5 mm.
The rescue system in a rocket can be implemented using an expelling charge or electronics with a small on-board computer.
The project is designed for printing without the use of supports.
The engine for the rocket is also printed on a 3D printer. (The engine project will be a little later) Its fastening is carried out due to the printed M20 thread with a pitch of 2.5 mm.
The rescue system in a rocket can be implemented using an expelling charge or electronics with a small on-board computer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
