Thingiverse
Mr. P Tie
door kbblackfox
6
Downloads
6
Likes
0
Makes
Mr. P's Lamp Tie
this is a homemade model i made instead of buying the tie that is sold for this lamp
you can increase the height of the ring if you dont want the small slip of light under it however that can only be seen from beneath
printing in 0.2mm layer height will finish the print in under 45 min
this is a homemade model i made instead of buying the tie that is sold for this lamp
you can increase the height of the ring if you dont want the small slip of light under it however that can only be seen from beneath
printing in 0.2mm layer height will finish the print in under 45 min
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!