Thingiverse
MRM 180 camera bracket
von GRay_111111
4
Downloads
0
Likes
0
Makes
UPDATED V3
clearance for props increased.
For MRM 180 frames
Print in TPU (will work in PLA ABS etc )
not tested as yet but should be fine for HS1177 Foxeer Monster etc.
May need a washer or two between camera and mount for some cameras.
(28.5mm wide camera?)
work in progress - so apply a little caution.!
clearance for props increased.
For MRM 180 frames
Print in TPU (will work in PLA ABS etc )
not tested as yet but should be fine for HS1177 Foxeer Monster etc.
May need a washer or two between camera and mount for some cameras.
(28.5mm wide camera?)
work in progress - so apply a little caution.!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!