Thingiverse
MTG - Deck Box
von TimTimTimTimTim
188
Downloads
162
Likes
8
Makes
This is my take on a simple stylized deck box for trading card games.
The box is designed to hold ~70x Sleeved standard cards and can be customized on the side with a Ø40mm emblem.
The box should be printed upright with no supports.
[UPDATE #1]:
So everything prints just fine and feels really nice in the hand, but the V1 model ended up being a little too *snug* for my liking.
Version #2 changes include:
1. Overall width increased to fit 70x sleeved cards (Dragonshield used for reference).
2. Extra clearance added to cards in Y-Axis to make it easier to slide cards into box.
3. Extra clearance added to cards in Z-Axis to prevent lid snagging.
4. Lid tolerances improved to give better fit.
The box is designed to hold ~70x Sleeved standard cards and can be customized on the side with a Ø40mm emblem.
The box should be printed upright with no supports.
[UPDATE #1]:
So everything prints just fine and feels really nice in the hand, but the V1 model ended up being a little too *snug* for my liking.
Version #2 changes include:
1. Overall width increased to fit 70x sleeved cards (Dragonshield used for reference).
2. Extra clearance added to cards in Y-Axis to make it easier to slide cards into box.
3. Extra clearance added to cards in Z-Axis to prevent lid snagging.
4. Lid tolerances improved to give better fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
