MTW Suppressor

It's a suppressor specifically designed for Wolverine Airsoft MTW. Fits inside the m-lok handguard. Hexagonal pattern on the outside.

Note that you can't mount anything on the sides, or the lower 45° mlok holes. You want to mount a flashlight etc, it needs to go on the upper 45° holes. Grips etc on the bottom are fine.

More volume means better suppression, and I didn't want to make the suppressor any longer, so the first chamber goes back around the barrel. The size is roughly 42mmx200mm.

Use foam/scotch-brite/whatever on the inside. You can also add a layer of painters tape on the baffles and shoot a hole through. Keep in mind that this might affect accuracy, but its better for suppression.

Depending on your printer, some parts might need some grinding to make a tight fit.

There is an option for a M4 brass insert to secure the suppressor, but if you make it fit tight enough, it shouldn't be necessary.

Correct orientation of the parts shown above, no supports needed