Multi-Spool Holder

Always good to get you spool off the gantry or power box. This design accommodates up to 8 spools and may be designed out of 3/4 pipe (best) or 1/2 pipe (best looking.) I did not glue mine and it holds very well. You may want to glue the vertical portion of the 1/2 inch version to ensure things don't tilt. Sizes are pretty straight forward, however, you will need to use a 1-7/8 (47.6mm) when connecting a T to an L. This is due to the depth of each part. Measurements are the same for both versions. When complete, drill 6 small holes at an angle to accommodate loose filament ends. On the 3/4 model, you may need to drill a 1/4 hole at the end then insert a dowel to keep the spools from sliding off. Some of my spools will not fit over the 3/4 cap and the caps do not slide off quickly.

Parts:
4 12" (305 mm)
2 8" (203 mm) vertical
2 6" (152.4 mm) vertical
1 6 3/4 inch (171.45 mm) base
4 2" (50.8 mm)
4 1 7/8 (47.6 mm)
5 L
6 T
1 + (cross)
2 caps