Multi-Use Case with Inserts

A small, strong case with a collection of optional inserts for different uses.   Case Use a section of 1.75mm filament inside the hinge to connect the lid to the base. Depending on your printer/setup, this hole maybe be on the tight side or a bit loose. If tight, drilling out the hole may help. If it is slightly oversized, I suggest melting the end of the filament piece with a soldering iron or lighter. This can be a standalone case or you can add inserts for more functionality. As requested, I have included the following lids with text to label the contents of your case: Blank Lid (default and easiest to print) AA Lid AAA Lid 9V Lid Digital Media Lid Nozzle Lid Print Settings Base and Lid can be printed with 3 perimeters and 0% infill. Using these settings, most walls will be solid. The combined print time was just over 3 hours for me. Optional Inserts Battery Holders  AA Holder - fits up to 6 AA batteries AAA Holder - Version 1 fits up to 6 AAA batteries, Version 2 (currently untested) holds up to 8 batteries 9V Holder - fits up to 2 9V batteries Digital Storage Holders - Can be used together or separately MicroSD Card Holder - fits up to 12 MicroSD cards in the lower section SD Card Holder - fits up to 6 SD cards in the upper section Dividers Full Divider - Splits the entire case into 2 compartments Upper Divider - adds 2 compartments on top - Can be used with the Lower Divider Lower Divider - adds 2 compartments on bottom - Can be used with the Upper Divider Nozzle Holders - Can be used together or separately  Upper Nozzle Holder - fits 14 standard nozzles (MK8 or E3D V6) Lower Nozzle Holder - fits 14 standard nozzles (MK8 or E3D V6) Print Settings No special print settings are needed for any of the inserts. I used 2 perimeters and 10% infill. Print times range from 35 minutes to 2 hours, depending on which insert(s) you choose to use.   The following filaments were used in the pictures above: Black Case polymaker PolyTerra Charcoal PLA Hatchbox Sparkle Gray PLA