Thingiverse
Multiangle Doorstopper with Hanger
von blecheimer
285
Downloads
274
Likes
2
Makes
**Where did I put that doorstopper?**
Do you know this feeling? You want to stop a door but you cannot find the doorstopper. Again!
With this doorstopper this will not happen to you. It has a hole so you can simply hang it to the doorhandle. And there is more: The doorstopper has two angles. A flat one for little gaps and a steep one for large gaps. Now doors are no challenge for you anymore!
Simple print, just 3 walls, 5 tops, 4 bottoms, 8% gyroid infill and no support. Ideal print for leftover filament as less than 6m / 20gr is needed.
Can be scaled if necessary.
Disclaimer:
This work by blecheimer is licensed under CC BY-NC-SA 4.0.
You are not allowed to copy this model to other 3D printing websites without my permission.
Do you know this feeling? You want to stop a door but you cannot find the doorstopper. Again!
With this doorstopper this will not happen to you. It has a hole so you can simply hang it to the doorhandle. And there is more: The doorstopper has two angles. A flat one for little gaps and a steep one for large gaps. Now doors are no challenge for you anymore!
Simple print, just 3 walls, 5 tops, 4 bottoms, 8% gyroid infill and no support. Ideal print for leftover filament as less than 6m / 20gr is needed.
Can be scaled if necessary.
Disclaimer:
This work by blecheimer is licensed under CC BY-NC-SA 4.0.
You are not allowed to copy this model to other 3D printing websites without my permission.
blecheimer veröffentlicht auch auf
235 zusätzliche Modelle auf 3 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
