Multiboard Nickel Coin Tool

I made this to help register and more easily start threaded Multipoint pieces without damaging the slot for reuse or removal. Keeping the part head parallel to the surface takes a lot of the frustration out of the process and is much easier with this. There are two versions - Basic and Winged. The models here is sized for use with a U.S. Nickel coin. Once printed, set the tool flush side up on a flat, stable surface and push the coin through the wider slot until it is fully seated and peaking out of the recessed side slot underneath. I use a pair of non-marring slip-joint pliers sometimes, but tap or two from a rubber mallet would work. It's meant to be a tight fit and resist the coin pushing out of the tool when starting the threads. When fully seated, a MultiPoint head piece will fit snugly and register on the coin edge flush. For storage, included are two "mounting spots"; one a flush screw and the other raised snap piece. In practice, I find the winged option to be my g