Multiboard Paper Ream Hanger

I designed this to hang reams of printer and notebook paper on my Multiboard. Naturally you need a few to make it work, I'm going with 8 (paper in landscape position, 4x hangers along the bottom, 2x on each side). Doesn't look like much, but I've tested, it gets the job done.

If you print it without support, the Multiboard snap on the back gets a bit dodgy on the bottom; but I found that smoothing it a bit with a razor knife after printing was still a lot quicker and easier than removing supports, especially since my slicer likes to put support on the interior of the snap as well. Just a little shaving off the bottom of the snap and it's working great for me.