MakerWorld
Organizers
Ver Modelo
Multiboard Snap Mount Caliper Holder
366
Descargas
50
Likes
200
Makes
A remix of the Multiboard Push-Fit Caliper holder to directly use the official multiboard remix snap fitting. I found the push fitting to be too loose for my preferences. By using the snap fitting directly, the caliper holder is solidly locked into place on the board. Confirmed to fit:NEIKO 01407A Electronic Digital Caliper (Amazon US direct link, no commission)The following settings were used to print this is one piece.Print orientation: Face-up, with critical region supports enabled.QualityLayer Height: 0.2mmWall printing order: Inner/Outer/InnerStrengthWall Loops: 3Infill: 15%, GyroidTop Shell: 5 layers, 1mm thicknessSpeedOuter Wall: 180 mm/sSlow Down for OverhangsSupportEnabledSupport Critical Regions Only
WithTheFlow también publica en
1 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!