MakerWorld
Gadgets
Vai al Modello
MultiBoom Mount for Wire Shelving Pole
35
Download
19
Likes
15
Makes
A long time ago, I printed StreelyDan's webcam mount. I recently switched out webcams and found that the Logitech C930e didn't tilt as far as my old cam did, so my view of the printer wasn't as good as it was previously. This led me to explore a bunch of possible solutions, but K2_Kevin came through with his MultiBoom system. Naturally, it didn't make sense to try to figure out a way to mount a 3-wide Multiboard to the pole, so I re-made the mount, mashing it up with the really nice design from the original mount I was using. You'll need 2x M3-12 screws and 2x M3 nuts to attach the mount to the pole. For my setup, I've got the mount (this piece here!), the swivel piece, a 100mm M/F arm, My setup, as shown uses the following parts:This mountFrom the MultiBoom Arm Kit:Swivel100mm Male/Female ArmThe accompanying fastenersThe ¼-20 adapter and locknut - pay attention to Kevin's print instructions here. You want 100% infill here as well as use some tough filament.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!