Multifunction Hex Driver Bit Holder Magnetic

Screwdriver in the end, T wrench in the middle, or in the last hole if you really need the torque. Space for 6x3mm magnets under each hole, and cut outs in the corners for a better fit.This bit driver will work with most ¼" bits on the market, depending on which fit you print.It is nice and compact at 75mm long, and weighs in at 10 - 15g depending on your infil choice.I would recommend starting with the .5mm “Normal” fit version, or the "Loose" fit if you are definitely putting magnets in. The "Tight" version is good if you don't mind using pliers to remove your bits. You may have to out a bit in and take it out a few times before it eases out. If the one you print is too tight then I would recommend getting a bit in as far as you can and then heating it with a hair dryer or some heat source and then pushing it the rest of the way in with some pliers. Please don't burn youself, even hair dryers can get the bits hot!Printing instrucionsMake sure you print thi