Thingiverse
MultiGP Jax Hinge
von BoomResolved
9
Downloads
7
Likes
0
Makes
Jax Hinge v4
I wanted a hinge for our chapter in two separate pieces. Two must be printed to form the hinge. It is to be connected by
1 x M12 or M14 Bolt
2 x washers
1 x Nut (preferably locknut)
It was designed for 1" schedule 40 PVC.
Flat top for easy printing. No supports needed.
It fits loosely snug to the PVC. As to accept the tolerances of 1" PVC. Recommend using glue. Or could possibly use tape around the pipe for a snug fit.
I wanted a hinge for our chapter in two separate pieces. Two must be printed to form the hinge. It is to be connected by
1 x M12 or M14 Bolt
2 x washers
1 x Nut (preferably locknut)
It was designed for 1" schedule 40 PVC.
Flat top for easy printing. No supports needed.
It fits loosely snug to the PVC. As to accept the tolerances of 1" PVC. Recommend using glue. Or could possibly use tape around the pipe for a snug fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
