Multipass Covid holder

So what makes this slightly different is this has registration marks on the base and the top. NO SUPPORT IS NEEDED. This makes it much easier to align the top/bottom up. Aslo there is a window in the back so you can see the spanish version of your covid card if needed

This fits a covid card thats around 3.25 x 4.25
reduce to 93.4% for a 3 x 4..that should be right.

The clear dome was NOT done with an sla printer. It was done with my ender 5 and clear flilament. I uses various sandpaper to make it smooth. I could have gone more clear, but dont have 2000 grit sandpaper, Most I had was 1000. I use a cloth with a little toopaste to polish it the best I could.

To make the dome here is my settings
.1 Layer height
240 nozzle for the pla ( I know its hotter than normal)
106 flow (cura) or Extrusion multiplyer 1.06 (Prusa)
100% infill
FAN OFF
3 perimiter
start with 120 grit, 130m , 1000grid wet, end with cloth buffing with toothpaste.
I know there are better methods..but