MultiPeg - Multiboard Tape Holder Peg

Update (4/27/2025): Looking to use this to hold greater loads than a roll of tape? Check out MultiPeg Tough! It's ready to handle greater loads, due to printing orientation.Oh look! Another tape holder for Multiboard, right? Yes, there are plenty of options, but I just didn't find any that I liked. This design is super simple - just a cylinder with a stop on the end to keep the roll of tape from falling off, and a Multiboard big thread on the other end. The profile contains 6 versions of the pegs - heights are 55mm, 80mm, and 110mm. Got more tape? Go for the big one! If you're hanging filament spools, the 80mm variant should be just about perfect for almost all spools. The new variations are the thickness of the peg/lip and the thread component height. This combo yields:6mm Thread Component Height45mm lip / 35mm peg35mm lip / 28mm peg20mm lip / 16mm peg (screw into a Moderate Weight-Bearing Snap)9mm Thread Component Height45mm lip / 35mm peg35mm lip / 28mm peg20mm lip / 16m