Thingiverse
Multiplex funjet Motormount
von fotoreb
7
Downloads
6
Likes
0
Makes
Made this motormount for Multiplex microjet.
ment for a 28mm outrunner inside.. bolthole is 13x13mm.
It`s hard to get the motor inside, use the force!!!
Use long wiers on the motor..
cut in to the foam for good fit.
V2 motormount is the blue one... wiers for motor goes under the mount.. cutt grove in foam...
bolthole 16mm an 19mm
ment for a 28mm outrunner inside.. bolthole is 13x13mm.
It`s hard to get the motor inside, use the force!!!
Use long wiers on the motor..
cut in to the foam for good fit.
V2 motormount is the blue one... wiers for motor goes under the mount.. cutt grove in foam...
bolthole 16mm an 19mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!