Multiplex MPX O'Ring wing connector

Housing for MPX type connectors to enable a reliable connection for servos on removable wings.

Type-A housing. Requires no trimming. The female side of the MPX connector is glued in from the front of the housing.


Type-C housing. The front of the Male connector requires a small amount of trimming to enable the pins to insert fully. (Please see pictures.)
The female part is inserted and glued in, from the rear of the housing

Both wing connector versions uses prop saver O'rings to hold the two sides together.

The angled holes can have 2mm Dia. rods inserted, to anchor the housing to the foam.

The housing has been tweaked to make them a better fit for the connector. I have noticed that some mpx connectors are slightly misaligned, when glued together. I suggest fitting both male and female together and sanding slightly to remove any misalignment.

Revised on 03/03/2020