Thingiverse
Multipoint 3D Star
door mmOne
113
Downloads
85
Likes
1
Makes
This design is also available on cults3D: [Multipoint Star](https://cults3d.com/en/3d-model/art/multipoint-3d-star-mmone)
This is a 26 point star. The points clip together without glue. As the star is completely hollow it can be easily illuminated. For a complete star you need to print 18 of the long tips and 8 of the short ones. The STLs in the download are sized to produce a ca. 20cm diameter star.
Assembly is nothing for the impatient, as you close up the star it gets harder to clip together the pieces. What helps is a pair of angled tweezers/pliers. Also, if you clip/unclip each interface once before, it goes together more easily the second time.
The assembly starts with a ring of four of the long tips. Then add a half sphere to one side by alternating between short and long tips. This pattern then gets mirrored to the opposite side. Check the pictures for some hints.
Printing
---
The STLs in the download are solid and should be printed in "Vase Mode".
In Slic3r/Pr
This is a 26 point star. The points clip together without glue. As the star is completely hollow it can be easily illuminated. For a complete star you need to print 18 of the long tips and 8 of the short ones. The STLs in the download are sized to produce a ca. 20cm diameter star.
Assembly is nothing for the impatient, as you close up the star it gets harder to clip together the pieces. What helps is a pair of angled tweezers/pliers. Also, if you clip/unclip each interface once before, it goes together more easily the second time.
The assembly starts with a ring of four of the long tips. Then add a half sphere to one side by alternating between short and long tips. This pattern then gets mirrored to the opposite side. Check the pictures for some hints.
Printing
---
The STLs in the download are solid and should be printed in "Vase Mode".
In Slic3r/Pr
mmOne publiceert ook op
20 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
