Thingiverse
munchkin board v2
por chowser89
32
Descargas
14
Likes
0
Makes
I was having trouble slicing the original so i modeled a new off of Tyrin's design, it doesn't have the coin spots, we don't use them.
i also added thumb spots to make getting the cards out easier and the text
i cut it into 3 pieces with very tight tolerances i didn't want to have to glue it but it can come apart if you need them too. i added a little section in the top right for the level and power counters we use
which are : https://www.thingiverse.com/thing:3984391
they work nice and make the math easy.
i made it so it would barely fit on my Prusa MK3s bed
i printed it at .3 just for time sake
each of the three parts take about 4 and half hours
and i need 4 in a week
i also added thumb spots to make getting the cards out easier and the text
i cut it into 3 pieces with very tight tolerances i didn't want to have to glue it but it can come apart if you need them too. i added a little section in the top right for the level and power counters we use
which are : https://www.thingiverse.com/thing:3984391
they work nice and make the math easy.
i made it so it would barely fit on my Prusa MK3s bed
i printed it at .3 just for time sake
each of the three parts take about 4 and half hours
and i need 4 in a week
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!