Mushroom with a frog

This is just a simple mushroom with a frog on the top. I made 2 styles for your choice of printing.

If you print the 1 piece mushroom it prints best at an angle (see photo), this uses the least amount of supports. This is my preferred method.
If you print the 2 piece, very minimal supports are needed (see photo), I originally used dowels to make it easier to assemble, however, they actually made it more difficult, so I eliminated them.

There are 2 base options, a simple spike that you glue to the bottom for placing in a flower pot, and a small meadow base that the mushroom snaps into. It is a tight fit, so glue is not needed.