Thingiverse
Muzzle Brake Adapter
von Digitaizen
90
Downloads
78
Likes
1
Makes
This was an exercise in creating a model of a muzzle break adapter so dimensions are might be off somewhat. If you are 3D-printing it, make sure to have supports but do not make them dense as it will be hard to remove them. On my 1st print (on the photo) I had to use a hot knife to cut out the supports which made it look a bit messy.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!