MUZZLELOADER RAMROD HANDLE

I wanted a handle for my ramrod to make it easier to use when cleaning my smokepole.

I used an existing handle design I found on Thingiverse (sorry, i never intended to upload this, so I didn't make note of the original poster. If that was your design, I'll be glad to reference your original design. I apologize in advance if what I've done is a major Thingiverse faux pas!).

Anyway, I made a cavity that fits a 10-32 x 1" bolt (from hardware store). Used methylene chloride solvent cement to fasten the halves together after a little sanding on the mating surfaces. If the bolt fit is tight, you may need to heat it up so it melts its way in as you put the halves together in a vise for assembly.

Shoot straight!