MWC Flip ez case

Update: I received my printer and got to test fit my original design. Very close but no cigar! one of the holes for a plug was off my 1mm and the usb connection sticks out of the board a little. I moved the hole over and put a slot so the usb will fit when installing the board. you will also need 4 10mm spacers to go under the board.
it is a tight fit, holes may need a little filing or drilling!

Case for mwc flip ez with RX pins going out the back (right angle) and the esc wires exiting underneath the board going inwards. The frame I am putting it on has a hole beneath the flight controller mounting area where the esc wires will enter. If all goes well, this case should help to hide the wires and tidy things up!