MakerWorld
Vehicles
Vai al Modello
MX-5 ND Sun visor
20
Download
18
Likes
4
Makes
Sun visor / mirror visor for MX-5 ND ST right side.Given that the cover breaks very frequently and Mazda doesn't only sell this piece but the whole sun visor. This model replace the mirror cover and works as the original.Printing:Recommend PETG or something stronger. I don't recommend the PLA, it will probably melt. I would recommend to use a black filament to have discrete look. Or the exterior color to match it perfectly.Layer hight 0,2 mmNo support needed. Be sure to save the metal spring plate from the original cover.The Pin on the left side is printed while for the oder I used a 1,75mm stainless steel pin (usually used for welding).For the two small bottom rubbers I used a neoprene or rubber soft tape. Installation:be careful that the small metal plate spring is correctly installed. Instal the sun visor in position.Insert the stainless steel pin from inside and push it trough the holes.Any improvements is well accepted 😊
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!