Cults3D
Tool
Model downloaden
SCROLLWHEEL INLAY MX MASTER 2S
0
Downloads
0
Likes
0
Makes
This is a new inlay for the scrollwheel in the Logitech MX MASTER 2S.
The rubber one originally there usually goes bad, this is a replacement.
Already splitted, ready to print and glues in when you have removed the old rubber bit.
Altough i disassemblied my mouse, it can be done without tearing apart your mouse, print, check that the grooves fit, adjust your details to a finer setting if your printer is printing to rough.
Remove the rubber in the middle of the scrollwheel, put one half of the printed in with a dab of glue, turn the scrollwheel and glue in the next bit.
Print in material of your choosing, tpu, pla, etc.
The rubber one originally there usually goes bad, this is a replacement.
Already splitted, ready to print and glues in when you have removed the old rubber bit.
Altough i disassemblied my mouse, it can be done without tearing apart your mouse, print, check that the grooves fit, adjust your details to a finer setting if your printer is printing to rough.
Remove the rubber in the middle of the scrollwheel, put one half of the printed in with a dab of glue, turn the scrollwheel and glue in the next bit.
Print in material of your choosing, tpu, pla, etc.
nimrooz publiceert ook op
5 extra modellen op 3 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
