MakerWorld
Vehicles
Voir le modèle
MX5 ND Wind Deflector (READ DESCRIPTION!)
95
Téléchargements
29
Likes
34
Makes
I've seen a couple folks on reddit making these things, but everyone's was a “work in progress” or they are selling them, so no one wants to publish the files! Whipped this up pretty quick and it should serve as a good cheap 3d printed replacement. IMPORTANT!! This should be considered a CONSUMABLE PART! It will LIKELY NOT LAST PAST A FEW YEARS!!! I printed this with Bambu Labs PETG-CF. The photographs only show the post-print. You should almost certainly do post processing for this to ensure longevity. I applied filler primer, sanded, repainted with gloss black ultracover, and a UV-Protection gloss clear coat. This attaches via 3M Automotive tape. Please pay very specific attention to the instructions for your automotive tape! Apply only in warm weather (70 degrees or above). Don't be bouncing off your rev limiter the first few days. Apply this part above the seal on the door, not to touch the seal. There should be slight room. Apply it as far back as you can. Think about
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !