Thingiverse
My 2 Axis Gimbal
by tromano32
35
Downloads
27
Likes
0
Makes
V1.0
Custom 2 axis servo gimbal for our hex copter.
Uses a Standard size servo for the horizontal and two sub micro servos for vertical.
Servos used:
1 - HS-422
2 - HK-15178
* if using two powered servos for the cam swing you must internally reverse one of the servos.
* after one of the servos was reversed, the two sub micro servos where slighting fighting each other ( due to low quality and no way to adjust the trim of just one servo ) so I used one servo for power while gutting the other servo and just used it as a bearing.
Custom 2 axis servo gimbal for our hex copter.
Uses a Standard size servo for the horizontal and two sub micro servos for vertical.
Servos used:
1 - HS-422
2 - HK-15178
* if using two powered servos for the cam swing you must internally reverse one of the servos.
* after one of the servos was reversed, the two sub micro servos where slighting fighting each other ( due to low quality and no way to adjust the trim of just one servo ) so I used one servo for power while gutting the other servo and just used it as a bearing.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
