My Bubble Clip

UPDATE 6/21/2020: Took out all sharp edges. All are rounded so it wont cut into your skin. Added a NEW version. Although I dont use a cover for my Bubble I do use tape. It appears that when I clean the sticky residue off the bubble with an adhesive remover it takes the glue off the 2 halves of the bubble and water gets inside. I made a holder that will keep the bandage (tape) off the bubble so there is no need to remove and sticky residue. I added holes in it so it can breath and let water drain. Not sure how well it will work. Id print it with TPU.

This will work for the Bubble and Droplet. The one that requires a strap has an extremely tight fit. I think it should be printed with TPU (flexible). The one that does not require the strap just clips on the Libre and the Bubble.
Bubble will be installed from the bottom. There is a lip on the top side thaat keeps it from falling out.
You will need to print the strap adjusters also and this link is a good place to start