My MPCNC Corner

As I started printing the MPCNC,

Going through the parts, I did not like the corner mount system,
Especially the belt restraint.

So I made a compound version ..

This restrains both X & Y tubes, **AND** clamps the belt All in one.

Also needed is a foot, to hold the tube,
and a foot for the build surface ..
In true Blue Peter style ..

> hear is one I made earlier ..
>https://www.thingiverse.com/thing:3835664

The belts loop around an M3 bolt, and get pushed in to the slot.

Tension needs to be done on the belt, but no issue,
I will probably design that next week :)


**NOTE**
>You need to print two of each corners, / Mirrored part,
>And 4 of the shoo.

> also needed are 2 - 4 * 100mm M6 Bolts,
> I used this one ..
>
>https://www.screwfix.com/p/easyfix-roofing-bolts-m6-x-100mm-10-pack/4964j