Thingiverse
My Personal Spool Holder
door Sinkha
2
Downloads
1
Likes
0
Makes
This is my personal version of the spool holder.
Additional parts
1 Threaded bar 8mm section of the length suitable for the width of your spool
2 Ball bearings 608
2 Nuts of 8mm
Personally I welded at the head of the threaded rod an 8mm Junction bushing and the result was excellent as well as very resistant.
As post production using the PLA maybe you have to sand a little bit the parts to allow the perfect fit.
For correctness I feel that the 2 spool holders are derived from the "Parametric universal spool holder" by rowokii http://www.thingiverse.com/thing:767317 and modified to improve the rotation once inserted the ball bearings, you can install it on any kossel profile.
Good job!!!
Additional parts
1 Threaded bar 8mm section of the length suitable for the width of your spool
2 Ball bearings 608
2 Nuts of 8mm
Personally I welded at the head of the threaded rod an 8mm Junction bushing and the result was excellent as well as very resistant.
As post production using the PLA maybe you have to sand a little bit the parts to allow the perfect fit.
For correctness I feel that the 2 spool holders are derived from the "Parametric universal spool holder" by rowokii http://www.thingiverse.com/thing:767317 and modified to improve the rotation once inserted the ball bearings, you can install it on any kossel profile.
Good job!!!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!