MySimpleBird

// a bird for a native american style flute
// makes the airway from the air hole to the sound hole
// bringing the air up and over a blockage in the tube
// (often a joint in bamboo-like reed)
// then to the sound hole
// passing over the cutting edge and making the sound

// printed bottom side up
// wet sand the side against the flute till nice and flat
// if the airway is too high you can sand more to reduce the air flow
// remove any burs, especially in the airway
// suggest 0.1mm layer height

// Shape of the bird can be important for a good sound
// adjust parameters below in openscad to fit your flute
// or stretch in your slicer
// find what works best for your playing

// there are two shape options below selected by adding and removing commented lines
// choose a flat airway or one that constricts in height as it goes
// and choose ears on the sides of the sound hole or a beard over it

// there are some good discussions of beards and ears in the org