N64 Controller Pack Dust Cover with Cable Wrap

The dust cover from https://makerworld.com/en/models/1081639 but modified with a cable wrap/organizer. There are two plates - one contains only a single cover, the other has two of them. The organizer just snaps together triangle-to-triangle. Gluing is not strictly necessary but might be beneficial for long term longevity. Just make sure the orientation is correct by verifying the triangles are pointing the same way. I recommend applying your glue to the wider portions of the cylinder, this will have the most contact. Note that there are tight tolerances - if you want this to “pop” in and out easily, you will need to spend a little time with a deburring tool, particularly on the “hole” on the dust cover. I found my “aftermarket” controllers fit it easily but my original controller needed me to clean it up. Also there will be supports inside the dust cover - you will want to use your deburring tool on these.