Thingiverse
N64 Phone Holder
von aaron86lee
20
Downloads
23
Likes
1
Makes
This phone holder has been designed to clip into the memory card slot of an N64 controller and allow you to download an emulator and play your favorite N64 games up close and personal!
It requires 1 to 2 rubber bands (a long one can be wrapped over all the pegs, if not use 2 like me), and maybe some protective sticky-back foam on the surfaces in contact with your phone for protection.
Before you print you may wish to check the length of the sliding back plate to ensure it is the correct length to hold your make of phone.
Enjoy!
It requires 1 to 2 rubber bands (a long one can be wrapped over all the pegs, if not use 2 like me), and maybe some protective sticky-back foam on the surfaces in contact with your phone for protection.
Before you print you may wish to check the length of the sliding back plate to ensure it is the correct length to hold your make of phone.
Enjoy!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
