Naboo Blaster Prop

Took the full file of [this blaster](http://www.thingiverse.com/thing:232147), cleaned it up a bit (removing holes), and sliced into 3 parts (the barrel, and the two halves of a vertical slice of the rest) for what seemed to me like easier printing. You may need to scale down again or rotate if your printer has a small bed.

I also added two holes in the handle where you can place a dime to help with the lining up of those pieces prior to applying the glue. (If you're going to print off only one of the handle files, use the "rev" file because I enlarged those holes slightly before printing off that half).
You'll also want to put some duct tape or something (just one layer) around the cylinder before attaching the barrel, because I didn't make it quite large enough to fit snugly without.