Thingiverse
Learning
Zum Modell
Nacho Fan
15
Downloads
19
Likes
0
Makes
Model for Major Hardware's Fan Show Down. Nacho Fan.
https://www.youtube.com/channel/UCUXW4gT27TOaDzKFyN-1tXQ
Made to fit a 120mm Noctua NF A12X25 12V PWM fan hub.
Designed with Solidworks Flow Simulation (Computational Fluid Dynamics), tweaked geometry to achieve a laminar exhaust stream and high exit velocity. Also focused on exceeding stock Noctua RPM, by minimizing rotational mass and optimizing centrifugal inertia. Theoretical noise of +24 dBA, though Real Life (tm) testing is required.
PLA01mmLH_Supported STL file is for 0.1mm Layer Height PLA only prints,
Has integrated supports. Do not add any additional supports.
Expecting blistering performance, and it looks hot :p
https://www.youtube.com/channel/UCUXW4gT27TOaDzKFyN-1tXQ
Made to fit a 120mm Noctua NF A12X25 12V PWM fan hub.
Designed with Solidworks Flow Simulation (Computational Fluid Dynamics), tweaked geometry to achieve a laminar exhaust stream and high exit velocity. Also focused on exceeding stock Noctua RPM, by minimizing rotational mass and optimizing centrifugal inertia. Theoretical noise of +24 dBA, though Real Life (tm) testing is required.
PLA01mmLH_Supported STL file is for 0.1mm Layer Height PLA only prints,
Has integrated supports. Do not add any additional supports.
Expecting blistering performance, and it looks hot :p
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
