Slicer Discord
Nama Claw Plug – Modelo 3D imprimible de Thingiverse Thingiverse

Nama Claw Plug

por johnkneev
1 Descargas
4 Likes
0 Makes
Ver Modelo
Everyone loves using Nama Claws on their continuous ridgeline hammock tarp system! Unfortunately, they are hooks, instead of closed loops. This makes it so your tarp can slide off when packing up. Never fear! With the Nama Claw Plug you can close the hook so your cord will not come off! These are intended to be permanently installed. You would then have your continuous loop, keyring, or what-have-you go through it. Easy peasy! To install, make sure to clean up print very well. Any imperfections will keep it from fitting. Use needle nose pliers to press in the hole.

I've also included the FreeCAD file I used to design it. You can edit the parameters via the Variables spreadsheet.
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Cama mín.
50 mm (Pequeño)
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección