Thingiverse
Nano Cube Light Head
door mrpatrikstar
9
Downloads
11
Likes
1
Makes
This is a light hood for the Dennerle Nano Cube Nano LED. It covers 4 sides so you don't get blinded by the light, e.g. if the Cube sits on your desk. The heatsink is still exposed.
The hood consists of 2 parts, the main part lightHood.STL and backside lightHoodBackside.STL, so it can be installed on the fly, without the need to disassemble the light. The 2 parts slide together. The second parts is not really necessary, because the main parts covers most of the perimeter. (I didn't print the backside yet, because the light reflection on the wall is not that bad)
To install, slide the main part with the 2 holes over the exposed railings and hook the other side up behind the heat sink. Insert the backside from below and side it into the side holes of the main part.
Print buttom up with no support.
The hood consists of 2 parts, the main part lightHood.STL and backside lightHoodBackside.STL, so it can be installed on the fly, without the need to disassemble the light. The 2 parts slide together. The second parts is not really necessary, because the main parts covers most of the perimeter. (I didn't print the backside yet, because the light reflection on the wall is not that bad)
To install, slide the main part with the 2 holes over the exposed railings and hook the other side up behind the heat sink. Insert the backside from below and side it into the side holes of the main part.
Print buttom up with no support.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
