Nano ITX case 1.0

This is version 1.0 of my Nano ITX case. You can fit an RTX 4060 or 5060 low profile 2 slot GPU inside. BUT, you will have to remove the shroud and install 3 additional fans. This case runs absolutely quietly, and the temps of the GPU are better than with the original shroud. CPU temps depend on your cooler and CPU. Max cooler height is 40mm, but I run fine with a Thermalright AXP90-X36 BLACK Low Profile. Must-have hardware: PSU: HD Plex 250 PSU; nothing else will fit! 9x M3 inserts. 3x 4mm deep; the rest can be up to 5mm deep. 8x M3 countersunk screws 12 mm long and 5x M3 8 mm long 3x 60mm fans with 25mm thicknes 2x 60mm fans with 15mm thicknes (for internal WiFi only) WiFi antenna extension cable PCIE riser cable 5 cm, total length 9 cm (don't buy one that's too long, or you get problems with not enough space.) Pushbutton switch, 16mm mounting diameter I printed my case with PC-CF for heavy use and traveling in mind. So it needed to be sturdy and take a beating during flights. If you