Nano Mounting Plate

Nano Mounting Plate

This is a mounting plate with screw posts to fit the screw hole pattern of an Arduino Nano. The post height (3 mm) provides enough clearance below the board for the soldered ends of standard pin headers. It may be necessary to trim some posts slightly to clear the solder if there is a header pin in the end position of a row.

EDIT 2/20/25: I've uploaded a version of this that uses M1.4 threaded brass inserts and machine screws vice the self tapping screws in this model. The new one is at...

https://www.thingiverse.com/thing:6955567

The plate is intended to be glued to an enclosure or a project board.

The plate size is 46.7 mm X 18.12 mm X 1 mm thick.

The posts are sized to take an M1.4 screw. There's an embedded label in the face of the plate as a reminder of the screw diameter required. It will probably work OK with 4 mm screws but a screw length of 5 mm is recommended.

The holes print at 1 mm diameter, completely through the part. It is recommended