Thingiverse
Nano simple&safe case
von Justy_guy
5
Downloads
4
Likes
0
Makes
(Sorry for sh**y photos)
A simple case for transporting Arduino Nano without worries about damage.
The bed surface can be used to place label with firmware name or something...
You will need a 2pcs 10x20x50mm sponge, one M3x20mm SHCS bolt and one about 25mm diameter rubber band. Blue material, rubber band and sponge recomended for extra protection :D
With 0,2 layer it takes about 1 and a half hour to print and put together.
A simple case for transporting Arduino Nano without worries about damage.
The bed surface can be used to place label with firmware name or something...
You will need a 2pcs 10x20x50mm sponge, one M3x20mm SHCS bolt and one about 25mm diameter rubber band. Blue material, rubber band and sponge recomended for extra protection :D
With 0,2 layer it takes about 1 and a half hour to print and put together.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
