Thingiverse
NanoKVM Lite Case with OLED Display
door troyanz
0
Downloads
2
Likes
0
Makes
I designed this case for my personal NanoKVM Lite setup because I wanted a compact and clean enclosure that perfectly fits the OLED display. It turned out great, so I am happy to share it with anyone who needs it.
The case features a convenient snap-fit design and holds together with built-in clips, so you do not need any screws or hardware to assemble it. The model is also optimized to print completely without supports.
To achieve the best results, you can use the exact print settings I used for this model. Print with a layer height of 0.2 mm, set the wall thickness to 0.8 mm (2 wall lines), and use an infill density of 20%. I printed this using PLA at a nozzle temperature of 210 degrees Celsius and a build plate temperature of 60 degrees Celsius.
The display guide rails inside the case have tight tolerances. If your print has too many blobs, zits, or rough layer lines due to incorrect retraction or seams, the OLED screen might not slide smoothly into its slots.
When assembling, m
The case features a convenient snap-fit design and holds together with built-in clips, so you do not need any screws or hardware to assemble it. The model is also optimized to print completely without supports.
To achieve the best results, you can use the exact print settings I used for this model. Print with a layer height of 0.2 mm, set the wall thickness to 0.8 mm (2 wall lines), and use an infill density of 20%. I printed this using PLA at a nozzle temperature of 210 degrees Celsius and a build plate temperature of 60 degrees Celsius.
The display guide rails inside the case have tight tolerances. If your print has too many blobs, zits, or rough layer lines due to incorrect retraction or seams, the OLED screen might not slide smoothly into its slots.
When assembling, m
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!