Nanoleaf Canvas Linker

I designed my own linker to 3D print because I didn't want to pay $7/each for new linkers.

Sharing the file here!

A few things to note:
- 3D printed linker is one-side only (it is not "double-sided" like original linkers).
- I added "triangle arrows" on the sides to show which side the exposed wiring should be on, to properly connect/touch the prongs on the canvas panel. Arrows also mark the "front face" of the linker.
- The big bulky areas near the middle (where the arrows appear) are for structural support and do not affect fitment, as PLA can be quite flimsy printed this thinly. (I didn't try to print this super-fine)
- As you can see, the middle (black) wire goes straight down the middle. The two wires on the sides (red and yellow) need to cross each other from one end to the other.
- I used 22 AWG SOLID core wire. I do not recommend stranded core wire because one of the small strands could possibly travel and touch a different wire and short the circuit.
- I added