Thingiverse
NANOMOUNT V2.5
von ThomasMakerFPV
0
Downloads
0
Likes
0
Makes
This is based on the nanostinky, however it uses the mobula6 screw mounts.
Its quite light, 0.65g, and i have a build thats 16.52g with it.
I print it right way up with supports but let me know if you have found better ways.
20deg to 45deg is provided.
It can handle decent indoor crashes, but I wouldn't take it outside to concrete.
Its quite light, 0.65g, and i have a build thats 16.52g with it.
I print it right way up with supports but let me know if you have found better ways.
20deg to 45deg is provided.
It can handle decent indoor crashes, but I wouldn't take it outside to concrete.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
