NanoPC-T4 Riser

A riser for the NanoPC T4. The objective is to get the SBC off the table, and provide proper support for an NVME disk which mounts under the board.

This is my first iteration on the subject, and may evolve over time into something a little more rack-mount friendly, but for now here's the design as is.

If you encounter issues, just LMK and I'll try to help modify the STL into tolerance.

Note: I drilled the holes in the risers w/ a power drill just to ensure they were tolerant of an M2 screw. Under certain circumstances you may not need to do this, but i suspect the hole is small enough, that its just easier to hollow it out based on your screw size.