Thingiverse
Napkin holder V2
door asmanovlev
5
Downloads
2
Likes
0
Makes
**updates**: increased spherical height, increased step of napkin holes, increased radius of stand.
If the stand doesn't fit in hole, use cold water to decrease for a little bit radius of stand, and use hot water to increase hole radius. It should fit tight, so you don't need to use glue.
**photo**: Printed using PLA.
If the stand doesn't fit in hole, use cold water to decrease for a little bit radius of stand, and use hot water to increase hole radius. It should fit tight, so you don't need to use glue.
**photo**: Printed using PLA.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
