Thingiverse
Narsil_Pegs_Leveled
door Woolfie99
16
Downloads
10
Likes
0
Makes
**I've removed nearly a dozen extra pegs from the file "*Narsil_Pegs_Leveled*". If you're printing the "broken" version of the sword, use the file "*Narsil_Shard_Pegs*".**
This file should replace the one named "10-repaired". The original had all of the pegs but one raised about a centimeter above the print bed. This, of course, caused the print to fail within five minutes.
To fix the file I used 123D Design to bring all of the pegs down to the proper level for printing.
**Update**
I just printed the file and all of the pegs turned out fine.
This file should replace the one named "10-repaired". The original had all of the pegs but one raised about a centimeter above the print bed. This, of course, caused the print to fail within five minutes.
To fix the file I used 123D Design to bring all of the pegs down to the proper level for printing.
**Update**
I just printed the file and all of the pegs turned out fine.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!