Thingiverse
NARUTO Kunai Knife
by TheWolf6
1
Downloads
0
Likes
0
Makes
Couldn't find a better build on here so i found one on YT, it's not my creation but the creator is here: https://www.youtube.com/watch?v=aZ5-JZnlDRs&ab_channel=WF3D
Give him thanks!
These are files for a Kunai. It is about 26 cm (~10,2 in) long.
The tip is rounded just a little bit so you can't hurt anybody and the print will be much cleaner on the tip.
The model is split into 2 halves for better printability with no supports. You'll need a rod with a diameter of 6 mm (~0,24 in) or an M5 rod with a length of max 180 mm (~7 in) for better stability.
Give him thanks!
These are files for a Kunai. It is about 26 cm (~10,2 in) long.
The tip is rounded just a little bit so you can't hurt anybody and the print will be much cleaner on the tip.
The model is split into 2 halves for better printability with no supports. You'll need a rod with a diameter of 6 mm (~0,24 in) or an M5 rod with a length of max 180 mm (~7 in) for better stability.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!