Naruto Kurama hueforge

file is ready to print, i suggest the brightest red u have Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used:PLA BambuLab Basic Black Transmission Distance: 0.6PLA BambuLab Basic Red Transmission Distance: 4PLA BambuLab Matte Lemon Yellow Transmission Distance: 4PLA BambuLab Basic Jade White Transmission Distance: 5 Swap Instructions:Start with BlackAt layer #9 (0.8mm) swap to RedAt layer #11 (0.96mm) swap to Lemon YellowAt layer #12 (1.04mm) swap to Jade White for the rest. Reminder:My models mostly cover the entire bed,this means the purge line is sometimesrunning through the bottom of the print.You have 3 options here:- Leave as is, you can just cut them of afterwards.- Remove immediately after the purge line is printed.- Scale the model:*** WARNING ***WHEN SCALING THE MODEL, BE SURE TO NOT SCALE THE Z-HEIGHT!The Z-height must always be as original, otherwise the printis messed up. If u want to support my work https://www.paypal.com/paypal